Cleavers control

Page last updated: Tuesday, 4 October 2016 - 3:55pm

Please note: This content may be out of date and is currently under review.

Control methods for cleavers (Galium aparine) a declared pest in Western Australia. Report the presence of this organism before undertaking a control measure.

Report the presence of this pest before undertaking control

Information about this pest can be found on the cleavers: declared pest page.

Chemical requirements

When using any agricultural chemicals please ensure that you always follow instructions on the label and any permit. Users of agricultural chemical products must always strictly comply with the directions on the label and the conditions of any permit. To view permits or product labels go to the Australian Pesticides and Veterinary Medicines Authority website.

Control options

Chemical control options can be found below. For other methods of control please refer to the cleavers: what you should know page.

Report the presence of this organism before undertaking control.

Chemical control options

Recommended herbicides

Actively growing:

Jaguar®; Barracuda; Bromicide MA

Herbicide: Jaguar® (South Australian recommendation)

Active ingredient

250g/L bromoxynil (Group C) + 25g/L diflufenican (Group F)

Rate of product/ha

1L

Time of application

Early post emergence of weeds. Up to one whorl stage of weed.

Remarks and other control measures

Apply to actively growing weeds. If crop or weed density is high it will be necessary to use high volume of application e.g. up to 100L/ha.

Similar product Barracuda® will give suppression.

Herbicide: Bromicide MA

Active ingredient

200g/L bromoxynil (Group C) + 200g/L MCPA (Group I) 

Rate of product/ha

750mL

Time of application

Two to four stems with one to three whorls of leaves/stem

Remarks

Use minimum of 50L water/ha

Herbicide: Fluroxypyr (Group I) (various trade names: see APVMA link)

Active ingredient

a) 200g/L fluroxypyr

b) 333g/L fluroxypyr

c) 400g/L fluroxypyr

Rate of product/ha

a) 1L

b) 300–900mL uptake spraying oil (winter fallow)

c) 500mL

Time of application

In wheat, oats, barley and triticale apply at three leaf to flag leaf (Zadok 13–39).

Weeds with one to three whorls of leaves: 600mL + 500mL uptake spraying oil for winter fallow.

Contact information

Pest and Disease Information Service (PaDIS)
+61 (0)8 9368 3080